Ares ham radio go kit is a portable, pre-packed collection of amateur radio gear designed for ARES (Amateur Radio Emergency Service) deployments, field exercises, and rapid response. The core idea is to grab one bag and be operational within minutes, regardless of whether you are heading to a served agency, a shelter, or a remote relay point.
What ARES Actually Expects From Your Kit
ARES is a volunteer program under the ARRL (American Radio Relay League) that provides emergency communications when normal infrastructure fails. A go kit is not a formal ARES requirement, but it is the standard way volunteers stay ready. The ARES Field Resources Manual and typical local emergency plans emphasize that a volunteer should be self-sufficient for 12 to 24 hours. That means your kit must include not just a radio, but power, antennas, logging tools, and basic personal supplies. The radio itself is only a third of the equation; the other two are power and antenna.
Core Radio Options: Handheld vs. Mobile vs. Base
Most ARES go kits center on one of three radio types, and many operators carry two. A handheld VHF/UHF transceiver (like a Yaesu FT-60 or a Kenwood TH-D74) is the minimum — it works for local nets and can hit a repeater from a hilltop. A mobile 50-watt VHF/UHF radio (like an Icom IC-2730 or a Yaesu FTM-400) is far more useful because it can reach distant repeaters and simplex nets, but it needs a larger battery and a proper antenna. A few ARES members add an HF radio (like an Icom IC-7300) for long-distance and NVIS (Near Vertical Incidence Skywave) work, which is valuable when repeaters are down. If you can only afford one, start with a 50-watt mobile unit and a battery, because handhelds often struggle in dense urban or wooded terrain.
Power: The Weakest Link in Every Go Kit
Commercial power is usually the first thing to fail in a disaster, so your kit must run independently. A 12V sealed lead-acid battery (17–35 Ah) is the budget standard; a LiFePO4 battery (like a Bioenno 12V 20Ah) is lighter and lasts longer but costs more. You also need a way to recharge: a foldable solar panel (100W is practical) and/or a DC-to-DC charger for your vehicle. Do not rely on the car battery alone — idling for hours wastes fuel and risks draining the starter battery. A common mistake is forgetting a DC power cable with Anderson Powerpole connectors, which are the ARES standard. Include a voltage meter and a spare fuse set. Test your battery under load once a month; a battery that reads 12.6V unloaded can drop below 11V when transmitting.
Antennas and Feed Lines That Actually Work
A radio without a good antenna is a paperweight. For VHF/UHF, pack a roll-up J-pole or a slim jim antenna that you can hang from a tree or a PVC mast; these outperform the rubber duck on a handheld by a huge margin. For HF, a 20-meter or 40-meter dipole with a 25-foot coax feed line is a reliable, lightweight choice. Also pack a 10-foot section of PVC pipe or a fiberglass mast to get the antenna up high — height matters more than power. Include a NanoVNA or an SWR meter to check that the antenna is resonant before you transmit, because a mismatched antenna can damage your radio. Always carry spare SMA-to-BNC adapters and a roll of electrical tape for quick field repairs.
Logging, Forms, and Coordination Tools
ARES operations require formal traffic logging. The standard is the ICS-213 general message form, and you should have a pad of these plus a clipboard. Many ARES groups use the ARES message form or the Radiogram form for formal traffic. Pack a notebook, pens, and a printed frequency list for your local repeaters and simplex frequencies — do not rely on a phone app, because cell networks may be down. A small tablet or laptop with a digital mode program (like FLdigi or Winlink) is useful for sending email-like messages over radio, but keep it in a waterproof pouch. Also include a printed copy of your ARES ID card and a list of your local emergency contacts.
Common Problems and How to Avoid Them
The most frequent failure in a go kit is dead batteries — both the radio battery and the accessory batteries. Always store the kit with batteries at 50–80% charge and recharge every 60–90 days. The second problem is connectors: SMA connectors on handhelds break easily, so use a BNC adapter and a short pigtail to reduce strain. The third is forgetting the microphone or the programming cable; a mobile radio without a mic is useless. Fourth, many operators pack too much gear and then cannot carry it; a go kit should be one backpack or one small Pelican case, not a trunk full of boxes. Finally, test your entire kit — not just the radio — by running a simulated net once a quarter. Set up the antenna, power the radio from the battery, and make a contact.
Costs and Realistic Budgets
A functional ARES go kit can be assembled for about $300–$500 if you buy used. A used 50W mobile radio (e.g., an older Yaesu FT-2900) costs $100–$150, a 35Ah lead-acid battery is $60–$80, a roll-up J-pole is $30, and a solar panel can be $100–$150. A new, high-end kit with a LiFePO4 battery, an HF radio, and a laptop can easily exceed $2,000. The ARRL and many local clubs offer loaner radios and training, so check with your local ARES Emergency Coordinator before spending money. Do not buy a cheap Baofeng as your only radio; they work but have poor receiver filtering and are not reliable for extended field use. A used name-brand radio is a better investment.
Safety and Deployment Etiquette
Safety comes first in any ARES deployment. Never climb a tower or a wet roof to hang an antenna; use a throw line or a weighted bag to get a line over a tree branch. Keep antennas away from power lines — a 20-foot dipole can touch overhead wires if you are not careful. Bring water, snacks, a headlamp, and a first-aid kit; you may be on site for hours. Do not transmit on frequencies you are not licensed for, and follow the served agency’s instructions about where to set up. Also, remember that ARES is a support role, not a first-responder role; you do not enter hazardous areas. If you are deploying to a shelter, coordinate with the shelter manager before transmitting.
Frequently Asked Questions
Do I need an ARES go kit even if I am a new ham? Yes, but start small. A handheld, a spare battery, a roll-up antenna, and a notebook are enough to participate in a local net. You can expand as you learn what your area needs.
What is the difference between a go kit and a bug-out bag? A go kit is specifically for amateur radio operations; a bug-out bag is for personal survival. Many hams combine them, but a proper go kit focuses on radio gear, power, and logging, while a bug-out bag has food, water, and clothing.
Can I use a go kit for non-emergency field operations? Absolutely. The same kit works for contests, field day, or portable operations in a park (POTA). The only change is that you might swap the ICS forms for a contest log.
How do I keep my go kit ready without draining the battery? Store the battery disconnected from the radio, and check the voltage monthly. If you have a LiFePO4 battery, it holds a charge for months; lead-acid needs a top-up every 30 days. Always label the battery with the last charge date.
Should I include a satellite or mesh radio in my kit? Only if your local ARES group uses them. Some groups now use ham radio mesh networks (like AREDN) for data, but that is an advanced option. Stick to VHF/UHF and HF first, and ask your EC what the group actually deploys with.
Related
- Persephone Color Palette: Hues of the Queen of the Underworld
- Persephone Hadestown Dress Style & Costume Guide
- Demeter Fragrance Best Sellers: Top Scents
How pages are sourced and corrected: Sources and editorial policy.