OneStopList

Gods and goddesses

Apollo Oil Tank Monitor Battery: Types, Life, and Replacement

Updated November 20, 2026

The Apollo oil tank monitor uses a 3V CR123A lithium battery, which typically lasts 2–3 years depending on signal strength and usage. When the battery runs low, the monitor displays a low-battery warning and should be replaced promptly to avoid losing remote tank-level readings.

What Is the Apollo Oil Tank Monitor?

The Apollo oil tank monitor is a wireless device that attaches to the top of a home heating oil tank. It uses ultrasonic technology to measure the distance from the sensor to the oil surface, converting that distance into a volume reading. The monitor transmits the data to a small indoor receiver or to a smartphone app via a hub, so homeowners can check their oil level without going outside. It is a popular retrofit for homes with standard 275-gallon or 330-gallon steel tanks.

Which Battery Does the Apollo Monitor Use?

The Apollo monitor is powered by a single 3-volt CR123A lithium battery. This is a common battery size used in cameras, flashlights, and some security sensors. The battery is housed in a compartment on the back of the monitor, accessible by twisting or sliding the cover. You can buy CR123A batteries at most hardware stores, electronics retailers, or online. Lithium CR123A batteries are preferred because they perform well in cold temperatures, which is important since the monitor sits outside in winter.

How Long Does the Battery Last?

Apollo states that the battery should last up to 3 years under normal conditions. Actual life depends on several factors:

  • Transmission frequency: If the monitor is far from the receiver or hub, it may transmit more often or at higher power, draining the battery faster.
  • Temperature extremes: Very cold weather can temporarily reduce battery capacity, but lithium cells recover when warmed.
  • Number of readings: The monitor takes readings periodically (often every few hours) and transmits them; more frequent transmissions use more power.
  • Build quality: Some users report batteries lasting only 1–2 years, especially in older units or with weak signal.

When the battery is low, the receiver or app shows a low-battery icon. Some models also beep or flash a red light. Do not ignore the warning—if the battery dies completely, you lose remote monitoring and must check the tank manually.

How to Replace the Apollo Battery

Replacing the battery is a simple task that takes about two minutes. Follow these steps:

  1. Remove the monitor from the tank by twisting it counterclockwise or pulling it straight up, depending on your model.
  2. Turn the monitor over and locate the battery compartment. It is usually a round cap that twists off.
  3. Remove the old CR123A battery and insert the new one, matching the + and – markings.
  4. Replace the cap and reattach the monitor to the tank.
  5. Check the receiver or app to confirm the monitor is transmitting again.

Some newer Apollo models have a sealed case, requiring you to unscrew small screws. Always consult your user manual for model-specific instructions. If you are unsure, contact Apollo customer support or a heating oil technician.

Common Problems and Troubleshooting

Besides low battery, users report other issues:

  • No signal: If the receiver shows no reading, the monitor may be out of range, the battery may be dead, or the monitor may have fallen off the tank.
  • Inaccurate readings: The ultrasonic sensor can be confused by foam or debris on the oil surface, or if the monitor is not seated flat.
  • Frequent low-battery warnings: This can happen if the battery is old, the monitor is transmitting too often due to a weak signal, or the battery contacts are corroded.
  • Monitor not pairing: After replacing the battery, you may need to re-sync the monitor with the receiver. Refer to the manual for pairing instructions.

If you have a wireless hub and app, ensure the hub is powered and connected to Wi-Fi. Sometimes a simple restart of the hub fixes connectivity issues.

Comparing Apollo to Other Oil Tank Monitors

Apollo is one of several brands in the market. Others include Watchman, Smart Oil Gauge, and Enviro. Here is a quick comparison:

  • Apollo: Uses ultrasonic sensor, battery-powered, wireless receiver or app. Known for reliability and easy installation. Battery replacement is required every few years.
  • Watchman: Also ultrasonic, but some models are wired to a 12V transformer. No battery changes, but installation may require an outlet.
  • Smart Oil Gauge: Uses a float sensor that sends data to a smartphone app via Wi-Fi. Runs on AA batteries, which last about a year.
  • Enviro: Similar to Apollo but uses a different mounting system. Battery life is comparable.

Apollo is often preferred for its long battery life and simple retrofit design. However, the need to replace the CR123A battery is a minor drawback compared to wired units.

Cost and Where to Buy Batteries

A single CR123A battery costs about $3–$8, depending on brand. You can find them at:

  • Hardware stores (Home Depot, Lowe’s)
  • Electronics stores (Best Buy, Batteries Plus)
  • Online retailers (Amazon, eBay)

Buying a four-pack is often cheaper per battery. Some users prefer brand-name batteries like Duracell or Energizer for reliability, but generic lithium cells work fine as long as they are 3V CR123A.

Safety and Disposal

Lithium batteries can be hazardous if punctured or exposed to high heat. Do not attempt to recharge a CR123A battery unless it is explicitly marked as rechargeable. Dispose of used batteries at a recycling center or a hazardous waste facility—do not throw them in the trash. If the battery leaks, wear gloves and clean the compartment with a dry cloth, then replace the battery. Avoid mixing old and new batteries, and always use the same type.

Frequently Asked Questions

How do I know when my Apollo battery is low?

The receiver or app will show a battery icon or a low-battery message. Some models also beep. If you see this, replace the battery soon.

Can I use a rechargeable CR123A battery?

Rechargeable CR123A batteries exist, but they have a lower voltage (about 3.0V nominal, but often 3.2V when fully charged) and may not last as long. Apollo recommends a non-rechargeable lithium battery. Using a rechargeable one might work, but it could affect accuracy or battery life.

Why does my monitor say low battery even after replacing it?

If the warning persists, the battery contacts may be dirty, the battery may be defective, or the monitor may have a fault. Clean the contacts with a pencil eraser and try a different battery. If the problem continues, contact Apollo support.

Will the monitor work without a battery if it is wired?

No, the Apollo monitor is battery-powered only. It does not have a wired option. If you want a wired monitor, consider other brands.

How do I reset the Apollo monitor after battery replacement?

Most models automatically reconnect after a battery change. If not, press the pairing button on the monitor and the receiver simultaneously, as described in the manual.

Related

How pages are sourced and corrected: Sources and editorial policy.